Nikon COOLSHOT - Manual (Page 19)

36 37
En
Jp
Fr
Es
Pt
Ru
Se
Nl
De
It
Dk
Pl
Hu
Cz
Fi
No
Ro
En
Jp
Fr
Es
Pt
Ru
Se
Nl
De
It
Dk
Pl
Hu
Cz
Fi
No
Ro
Others
This Nikon Laser Rangefinder is a basic rangefinder. Its results cannot be used as official evidence.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Troubleshooting/Repair
If your Nikon Laser Rangefinder should require repair, please contact your local dealer or the store where you
purchased it. Before doing so, you are advised to consult the Troubleshooting/Repair Table below.
Symptom Check Points
Unit does not turn on
(LCD fails to illuminate)
● Depress POWER ON/Measurement button. (near side, top of the body)
● Check the battery insertion
● Replace the battery with a new one.
Unable to measure the distance
● Be sure that nothing, such as your finger or a strap, is blocking the
laser emission aperture and laser detector aperture on the objective
lens side.
● Be sure that the laser emission aperture and laser detector aperture
on the objective lens side are clean. Clean them if necessary.
● Be sure that the target shape and condition are appropriate to reflect
the laser beam.
● Replace the battery with a new one.
[- - -] (“Cannot measure”) appears
● Be sure to hold the unit steady while measuring.
● Be sure the target is within measurement range
Measurement range: 4.5-550m/5-600 yards
Closer target, located inside the
measurement range, cannot be
measured
● Be sure that nothing, such as leaves or grass, is between the Nikon
Laser Rangefinder and the target.
Target beyond a certain distance
cannot be measured
● Be sure that nothing, such as leaves or grass, is between the Nikon
Laser Rangefinder and the target.
Measurement result is unstable
● Replace the battery with a new one.
● Be sure that the target shape and condition are appropriate to reflect
the laser beam.
● Be sure to hold the unit steady while measuring.
● Be sure that nothing, such as leaves or grass, is between the Nikon
Laser Rangefinder and the target.