Nikon S9400 - S9500 - Manual (Page 142)

E22
Re
feren
ce
S
ect
io
n
Connecting the Camera to a Printer (Direct Print)
Users of PictBridge-compatible (
F23) printers can connect the camera directly to
the printer and print pictures without using a computer.
Connecting the Camera to a Printer
1
Turn off the camera.
2
Turn on the printer.
• Check the printer settings.
3
Connect the camera to the printer using the included USB cable.
• Be sure that the plug is oriented correctly. When disconnecting the cable, do not pull
the plug at an angle.
4
The camera is automatically turned on.
• When connected correctly, the PictBridge startup screen (1) is displayed on the
monitor screen of the camera. Then the Print selection screen (2) is displayed.
B
If the PictBridge Startup Screen Is Not Displayed
Turn the camera off and disconnect the USB cable. Set the Charge by computer option ( E80) in
the camera’s setup menu to Off and reconnect the cable.
B
Notes on Power Source
• When connecting the camera to a printer, use a fully charged battery to prevent the camera from
turning off unexpectedly.
• If the AC Adapter EH-62F (available separately) ( E99) is used, the COOLPIX S9500/S9400 can be
powered from an electrical outlet. Do not, under any circumstances, use an AC adapter other than
the EH-62F. Failure to observe this precaution could result in overheating or damage to the camera.
15/05/2013 No. 31 [ 32]
Print selection