elektraLite CP20 - Manual (Page 10)

9
Editing Cues
To edit an existing cue, first recall the cue as described in the previous paragraphs. Make any changes as needed
using the control faders or joystick. You may need to turn on or off fixtures when you are editing. Once
finished doing your editing Press "Enter", "Cue", then adjust the "Xfade" if desired. Select a cue number to
store the edited cue by using either the numerical keypad or the Direct Access Keypad. You can write over the
original cue number or you can select a different one if you are copying this cue to another location. Finally
press "Enter" again to store the edited cue. If you are writing over the original cue just press "Enter" again to
overwrite without changing the cue number.
Deleting a Cue
Okay, so you screw it up and you want to “terminate it”! This is pretty easy to do. First press enter cue and the
cue number you want to delete. For example cue 750. So the display will read:
ENTER CUE 750
Then press the Delete keyswitch. The display will now read:
ERASE CUE 750?
+YES -NO
If you press the + keyswitch then the display will read
CUE 750
ERASE D
The cue has been terminated!
Fine Pan and Tilt
The joystick has a "fine" mode for pan and tilt control. To enable fine mode, press the fine button. Pressing
“fine” again will toggle fine mode on and off.
With the joystick in fine mode, the pan and tilt will move in small increments making it easier for exact
positioning. It uses the fine channels for pan and tilt in the fixtures attributes. So if the fixture does not have Pan
Fine and Tilt Fine then fine control will not work.