elektraLite CP20 - Manual (Page 47)

46
Loading a show into the CP20 from a disk
First, press “Menu” then using the "Å" and "Æ" keys go to the menu selection on the CP20 labeled
PRESS “ENTER” TO
LOAD MEMORY FILE
At this point make sure the disk with the correct show file is loaded in the disk drive then press “Enter”. The
screen will now display the following message:
RECEIVING FILE
FROM DISK
The upload time will depend on the size of the show file. So don’t remove the disk after a few seconds. Once
the file has been uploaded the screen display will read.
ELEKTRALITE CP-20 V x.xx
Updating Software
To update the software, first press “Menu”, then using the "Å" and "Æ" keys go to the menu selection on the
CP20 labeled
PRESS “ENTER” TO
UPDATE SOFTWARE
At this point make sure the disk with the correct software version is loaded in the disk drive, then press “Enter”.
The screen will now display the following message:
RECEIVING
NEW PROGRAM
Once the program has successfully loaded the screen will display the following message:
ELEKTRALITE
CP 20 (V x.xx)
This display shows the latest software now loaded into the CP-20.