elektraLite CP20 - Manual (Page 32)

31
SYSTEM PROGRAMMING
There are a number of features and settings for the CP20 that are to be programmed during installation that
seldom if ever need to be set again. They are generally used by the installer to customize the system to the
particular installation. These are all accessed using the "Menu" switch. Any menu selection that involves setting a
value will be stored in battery backed memory.
Press "Menu" and you will be in the Menu directory. The menu has many different items for example:
PRESS “ENTER” TO
CHOOSE FIXTURES
Use the "-Å" and "Æ+" keys to select from the different menu items. In the display below, audio enable is the
current selection. To select that item press "Enter". The display will go to the audio enable menu where you can
then set the audio enable to the desired value. You do not need to press "Enter" once a menu item is
programmed. You can press any other switch to continue. The various menu items are explained in the
following paragraphs.
To exit out of the menu press the menu button a second time to get back to the root directory….which is, of
course:
ELEKTRALITE CP20
REVISION 1.1
Audio On/Off
The audio enable display reads:
AUDIO IN SENSE 9
0-LEAST, 9-MOST
When audio is on, chases will attempt to sync to the beat of the audio signal. If there is no signal present the
chase will not run. "AUD" will appear in the chase display next to "BPM". Xfade is automatically set to 0 when
a chase is controlled by audio. The audio sensitivity can be adjusted using the numerical keypad numbers 0
through 9.
Fixture Library
The fixture library is under the menu :
PRESS “ENTER” TO
CHOOSE FIXTURES
Chapter
8