elektraLite CP20 - Manual (Page 50)

49
When your receiver is ready, press "Go" to start the memory dump. The message "SENDING" will appear on
the CP10xt display. After the dump is complete the display will return to its previous state. The memory dump
will require approx. 244K of disk space. When sending a memory dump back to the CP10xt the message
"RECEIVING MEMORY" will appear in the CP10xt display. After the memory dump has been received the
message "MEMORY RECEIVED" will appear in the display. If the "received" message does not appear, then
the memory dump was improperly received. The memory dump takes several minutes. The CP10xt must not be
in enter cue, chase or macro mode when receiving a memory dump. The contents of the memory messages are
shown in the MIDI implementation chart which follows.
MIDI Implementation Chart
NOTE: All numbers are in hexadecimal unless stated otherwise.
Continuous Controllers (sent and received)
Bn 00 bb Bank select
Bn 01 vv Xfade Speed
Bn 02 vv Chase Speed
n=MIDI channel (0-F)
bb=bank (0-7)
vv=7 bit value (0-7F)
Program Changes (sent and received)
Cn 00 Blackout
Cn vv Cues, Chases and Macros
Note: cues, chases and macros are always preceded by a bank select message.
System Exclusive Messages
F0 00 00 19 06 01 dd ... F7 Memory dump
F0 00 00 19 06 00 F7 Memory dump request
dd=approx. 244K data bytes.