Sony DAR-RD100 - Manual (Page 22)

22 GB
Connecting the audio cords
If you use your TV’s speakers for listening to sound, connect the LINE 2 OUT jacks of the recorder to
the audio input jacks of your TV.
z Hint
You can connect an AV amplifier to the DIGITAL OUT
(COAXIAL) jack. Make the appropriate settings under
[Audio] setup (page 80). All the surround effects of the
system cannot be used.
Notes
• Do not connect your TV’s audio output jacks to the
LINE IN (AUDIO L/R) jacks at the same time. This
will cause unwanted noise to come from your TV’s
speakers.
• Do not connect the LINE 4 IN (AUDIO L/R) and LINE
2 OUT (AUDIO L/R) jacks to your TV’s audio output
jacks at the same time. This will cause unwanted noise
to come from your TV’s speakers.
To use the recorder’s surround function
With the audio connection above, you can enjoy
virtual surround sound effects created from the left
and right speakers.
Press SUR on the remote to turn on the function.
[SUR ON] appears on the TV screen
To turn off the function, press SUR again.
VIDEO
AUDIO
INPUT
L
R
AERIAL
IN
OUT
LINE 3 / DECODER DIGITAL OUT
LINE 1 - TV
COAXIAL
PCM/DTS/ MPEG/ DOLBY DIGITAL
COMPONENT VIDEO OUT
PB/CB
PR/CR
Y
LINE 2 OUT
L
AUDIO
VIDEO
R
LINE 4 IN
L
AUDIO
VIDEO
R
DIGITAL OUT VIDEO OUT SELECT
RGB
COMPO- NENT
OPTICAL
S VIDEO
LINE 2 OUT
PCM/DTS/MPEG/
DOLBY DIGITAL
LINE 2 OUT
L
AUDIO
VIDEO
R
(red)
TV, projector, or AV
amplifier (receiver)
Audio cord
(not supplied)
: Signal flow
to LINE 2 OUT (AUDIO L/R)
(white) (white)
(red)