AT&T CL84109 - Manual (Page 14)

Getting started
8
Battery installation & charging
Install the battery as shown below. Once you have installed the battery, the
screen indicates the battery status (see table below). If necessary, place the
handset in the telephone base or charger to charge the battery. For best
performance, keep the handset in the charger when not in use. The battery is
fully charged after 16 hours of continuous charging.
See the table on page 85
for battery operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10 minutes to give the handset enough charge to use the telephone
for a short time. The screen shows
LOW BATTERY and the backlight is off until
you have charged the battery without interruption for at least one hour. The
following table summarizes the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank. Battery has no charge and
the handset cannot be used. Charge without interruption until
the screen shows
LOW BATTERY
(at least 10 minutes).
The screen shows PLACE IN
CHARGER and flashes.
Battery has very little charge
and the handset cannot be
used. Charge without interruption until
the screen shows
LOW BATTERY
(at least four minutes).
The screen shows LOW
BATTERY and flashes.
Battery has enough charge
to be used for a short time. Charge without interruption until
the screen shows
HANDSET X (at
least one hour).
The screen shows
HANDSET X. Battery is charged. To keep the battery charged,
place it in the charger when not
in use.
Step 1
Plug the battery connector
securely into the socket
inside the handset battery
compartment, matching the
color-coded label. Insert
the supplied battery with
the label
THIS SIDE UP
facing up as indicated.
Step 2
Align the cover flat against
the battery compartment,
then slide it upwards until it
clicks into place.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every
minute.