AT&T CL84109 - Manual (Page 73)

67
Appendix C
Expansion handset
Adding and registering handsets (optional)
Handsets purchased separately (AT&T CL80109) need to
be registered to the telephone base before use. When first
purchased, all expansion handsets show
NOT REGISTERED on
the screen. New handsets may need to be charged without
interruption for at least 10 minutes before registering to the
telephone base.
To register a handset to your telephone base
1. Make sure the handset is out of the charger and shows
NOT
REGISTERED before you begin registration.
2. Press and hold
INTERCOM
/HANDSET LOCATOR on the
telephone base for about four seconds (until the red IN USE
light on the telephone base is on) and then release
the button, the screen of the telephone base shows
REGISTERING... The IN USE light remains on while the
telephone base attempts to register a handset.
3. Place the unregistered handset into the charger, PRESS
HNDST LOC 4 SEC ON BASE shows on the handset screen.
The handset is now registering with the telephone base. The
handset then shows
PLEASE WAIT... and it takes up to 60
seconds to complete the registration. There is a beep sound
when the registration is successful. The handset shows
HANDSET X REGISTERED, with X being the handset number
(1-12).
NOTES:
1. If the registration is not successful, the screen shows NOT REGISTERED. To
reset the handset, remove the handset from the charger, then start again
from step 2 above.
2. You cannot register a handset if any other system handset is in use.
NOT REGISTERED
PLEASE WAIT...
HANDSET X
REGISTERED
PRESS HNDST LOC
4 SEC ON BASE
--
REGISTERING...
MSG#
NOT REGISTERED