AT&T CL84109 - Manual (Page 28)

22
Telephone settings
Answering system settings (handset only)
Remote access code
To access your answering system remotely from any touch tone
phone, you need to enter a two-digit number (10-99). Unless
you change it, the remote access code is 19.
To change the remote access code on a cordless handset:
1. When the handset is in idle mode, press
MENU/
SELECT
to
enter the main menu.
2. Press
MENU
/SELECT again.
3. Press q CID or DIRp to scroll to >ANS SYS SETUP, then
press
MENU
/SELECT.
4. Press q CID or DIRp to scroll to >REMOTE CODE, then press
MENU
/SELECT.
5. Press q CID or DIRp to change the remote access code.
6. Press
MENU
/SELECT to confirm your setting. A confirmation
tone sounds.
Message alert tone
When the message alert tone is set to
ON, and there is at least one new
message, the telephone base beeps every 10 seconds. Unless
you change it, the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting on a cordless handset:
1. When the handset is in idle mode, press
MENU/
SELECT
to
enter the main menu.
2. Press
MENU
/SELECT again.
3. Press q CID or DIRp to scroll to >ANS SYS SETUP, then
press
MENU
/SELECT.
4. Press q CID or DIRp to scroll to >MSG ALERT TONE, then
press
MENU
/SELECT.
5. Press q CID or DIRp to choose between ON and OFF.
6. Press
MENU
/SELECT to confirm your setting. A confirmation
tone sounds.
NOTES:
1. The message alert tone beeps only if all the conditions below are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
2. To temporarily turn off the message alert tone, see page 56.
>
ANS. SYSTEM
DIRECTORY
>
ANS SYS SETUP
PLAY MSGS
>
REMOTE CODE
MSG ALERT TONE
REMOTE CODE
19
>
ANS. SYSTEM
DIRECTORY
>
ANS SYS SETUP
PLAY MSGS
>
MSG ALERT TONE
ANSWER ON/OFF
MSG ALERT TONE
ON