IPitomy IP1000 User Guide User Manual
Page 21
PPPoE –Some DSL service providers use PPPoE (Point-to-Point Protocol over
Ethernet) to establish Internet connections for end-users. If DSL connection to
Internet is using, check service provider for the connection provisioning type. Enable
it if PPPoE is used.
o
User Name and Password – Enter the user name and password provided by
service provider. User name and password will be used for authentication
while establishing PPPoE connection.
o
Max Idle Time and Connect on Demand – If the connection stay inactive for
over a specific period time (Max Idle Time) the PPPoE connection may be cut
off. Assign 0 to Max Idle Time field will always keep the connection no matter it
is active or not. If Internet connection has been terminated due to inactivity,
automatic re-establishment for Internet connection will be invoked by any
attempt of access to Internet if the Connect on Demand field is checked.
o
Keep Alive and Redial Period – If Keep Alive is enabled, system will
periodically check the Internet connection. If the connection is down, then the
system will automatically re-establish the connection. To use this option, click
the radio button next to Keep Alive. The Redial Period is the time period to
trigger system to check the Internet connection; default Redial Period is 30
seconds.
PPTP – Point-to-Point Tunneling Protocol (PPTP) is a service that deployed in
Europe and Israel only.
o
Internet IP Address – Normally the static IP address is a public IP address
provided by service provider; it is used for connecting to Internet. This IP
address must be assigned from IP provider.
o
Subnet Mask – The subnet mask Information should be provided along with
IP address.
o
Default Gateway – The IP address for the default network gateway, it is the
information service provider should provide.
o
User Name and Password – Enter the user name and password provided by
service provider. User name and password will be used for authentication
while establishing PPTP connection.
o
Max Idle Time – If the connection stay inactive for over a specific period time
(Max Idle Time) the Internet connection may be cut off. Assign 0 to Max Idle
Time field will always keep the connection no matter it is active or not.
o
Connect on Demand – If Internet connection has been terminated due to
inactivity, automatic re-establishment for Internet connection will be invoked by
any attempt of access to Internet if the Connect on Demand field is checked.
o
Keep Alive and Redial Period – If Keep Alive is enabled, system will
periodically check the Internet connection. If the connection is down, then the
system will automatically re-establish the connection. To use this option, click
the radio button next to Keep Alive. The Redial Period is the time period to
trigger system to check the Internet connection; default Redial Period is 30
seconds.
L2TP –Layer 2 Tunneling Protocol (L2TP) is a service that tunnels Point-to-Point
Protocol (PPP) across the Internet. It is used mostly in European countries. Check
with service provider for necessary setup information.
o
Internet IP Address – Normally the static IP address is a public IP address
provided by service provider; it is used for connecting to Internet. This IP
address must be assigned from IP provider.
Copyright
© IPitomy Communication, LLC
16
0007VRF