Panasonic RRXS410E - Manual (Page 26)

VQT3T14
26
26
When VAS (Voice Activated System) is set, if silence continues for approx. 2 seconds
during microphone recording, the recording is paused automatically. If the unit detects
sound, the recording resumes.
* When the recording level adjustment is MANUAL ( ➜ page 22), even if the VAS setting is set to ON,
the setting does not change to the VAS recording.
* For important recording, set the VAS setting to OFF.
* If the “LOW CUT FILTER” setting is “ON”, low frequency sound may be cut out and VAS recording
may not activate. In this case, change the “LOW CUT FILTER” setting to “OFF”. ( ➜ page 21)
* If the recording is paused with no sound state, “ ” blinks. When [* REC] is pressed from this
recording pause state, the status is changed to normal recording pause state and “ ” lights up.
While “ ” is blinking, the “AUTO POWER OFF” ( ➜ page 52) function does not operate.
Preventing unnecessary recording (VAS)
• Set the recording level adjustment to AUTO
beforehand. ( ➜ page 22)
• Press [g STOP/RETURN] to stop the unit.
1 Press [MENU].
2 Press +, – to select “MIC REC MENU”
and press [q OK] to enter.
3 Press +, – to select “VAS” and press
[q OK] to enter.
4 Press +, – to select “ON” and press
[q OK] to enter.
(The factory setting is “OFF”.)
To exit the setting screen, press
[F2 (CLOSE)].
“ ” is displayed.
To start VAS recording, press [* REC].
Adjusting the VAS operation level:
Press u, i during VAS
recording.
(The factory setting is “3”.)
* You can adjust the sound detection level from 1 to 5.
* If the audio to record is low, increase the VAS
value (sensitivity level). If the sound is loud,
decrease the VAS value.
g STOP/RETURN
F2
MENU
* REC
VQT3T14_RR-XS410_400-E_En.indd 26 VQT3T14_RR-XS410_400-E_En.indd 26 2011/06/22 15:00:27 2011/06/22 15:00:27