Panasonic WJ-NV200 - - Manual (Page 32)

32 33
Step 1
Display the images from the camera to search on a
1-screen. (☞ Page 19)
Step 2
Click the [Search] button on the playback operation
panel. (☞ Page 25)
→ The VMD search panel is displayed.
Step 3
Designate the time range to search.
Set the year, month, day and time of the start and end
point by clicking the respective [
D] / [C] buttons.
Step 4
Click the [Search] button.
→ This will run a VMD search within the designated
search range and display a list of results. Switch
between list pages by clicking the [Prev page]/
[Next page] buttons.
Search and play recorded images triggered by motion
detection (VMD search)
Search images recorded with a camera supporting the VMD search function by the date motion was detected
and play them. Click a time and date on the result list to play corresponding recorded images.
Important:
• To perform the motion detection search, it is necessary to configure the settings of the connected cameras
that support the motion detection search function in advance. Refer to the "readme.txt" on the provided
CD-ROM about the supported camera. Refer to the operating instructions of the camera in use for further
information.
Note:
• The VMD search function searches the entire
camera image by default. To designate a search
area, click the [Setup] button next to [Detection
area / Mask duration] on the "VMD search setup"
panel. (☞ Page 33)
• It may take some time until the search results are
displayed.
Step 5
Select the line with the desired list, and click the play
button on the playback operation panel. (☞ Page 25)
→ Playback will start from the time and date select-
ed.
Note:
• Playback can also be started by double-clicking
the desired time and date line.