Festo Модуль перемещения HSP - Manual (Page 43)

HSP−...−AP/A S
Festo HSP−...−AP/AS 0508a English
43
Static adjustment of the end positions:
S Remove the protective cover of the
handling module.
S Exhaust the drive.
Setting the Z−stroke:
1. Loosen the locking nut of the stop
screw (A).
2. Use a hexagon socket screw key to turn
the stop screw at the same time with
counter force against the locking screw
unti the receive position (B) is reached.
3. Tighten the locking screw (tightening
torque: 1 Nm).
4. Repeat the procedure for setting the
release position.
Setting the Y−stroke:
Warning
Sudden movements of the actuators when they are under pressure during the
setting of the
y−stroke can cause injuries and loose link parts can damage the
HSP−... .
S Exhaust the drive before you loosen the fastening screws of the link parts.
S After setting the Y−stroke: Make sure that the fastening screws of the link
parts are screwed tight.
In this way you will avoid injury to human beings and damage to the device.
Please note
Loosen only the fastening screws of both link parts.
The fastening screws of the centre piece
7 between the link parts on HSP−16−...
and HSP−25−... must not be loosened.
Fig. 13
(B)
(A)