Festo Модуль перемещения HSP - Manual (Page 57)

HSP−...−AP/A S
Festo HSP−...−AP/AS 0508a English
57
12 Eliminating faults
Fault Possible cause Remedy
Hard knocking in
stroke end position Shock absorber defective Replace shock absorber
stroke end position
Stop element overloaded
Ĉ Work load too heavy Reduce speed
Work load too heavy
Ĉ Speed of moveable mass
too high
Faults in position
scanning Position of proximity switch
incorrect Correct position of proximity
switch
Incorrect type of proximity
switched used Use only proximity switches of
type SME/SMT−8−...
Proximity switch defective Replace proximity switch
Ferritic parts in vicinity of
proximity switch Use parts made of
non−magnetic materials
End positions not
reached Setting of the y−stroke and the
z−stroke not correct Adjust end positions
(seeĂchapter Fitting")
The double rollers
do not run smoothly
in the path guide Link parts offset Align link parts free of offset
(see chapter Fitting, Setting
the y−stroke")
Play of the vertical
guide rail in the end
positions Spring clamping element
defective Replace spring clamping
elements