Configuration 4 (config4) – address 36 – Cirrus Logic CS1631 User Manual
Page 33
CS1630/31
DS954F3
33
6.9 Configuration 4 (Config4)
–
Address 36
6.10 Second Stage Dim (S2DIM)
–
Address 37
S2DIM sets the minimum dim for second stage (flyback, buck, or tapped buck). The register value is an un-
signed integer in the range of 0
value255. Enforced minimum dim percentage dim
min
is determined by the
following equation:
6.11 Maximum TT (TTMAX)
–
Address 38
TTMAX sets the maximum allowable target period for the second stage TT. The register value is an unsigned
integer in the range of 0
value255. The maximum TT period is determined by:
The maximum period for TT can be configured from 6.35
s to 1.63835ms.
7
6
5
4
3
2
1
0
T2CH1GAIN5 T2CH1GAIN4 T2CH1GAIN3 T2CH1GAIN2 T2CH1GAIN1 T2CH1GAIN0
SYNC
POL_ZCD
Number
Name
Description
[7:2]
T2CH1GAIN[5:0]
Sets T2 compensation gain T2
CH1CompGain
for channel 1, which is required
when T2 measurement compensation is enabled for flyback designs. The
value is an unsigned integer in the range of 0
T2CH1GAIN[5:0]<63. Com-
pensated T2 time T2
Compensated
used in the second stage charge regulation
loop is given by:
where,
T2
CH1CompGain
is a decimal number in the range of 0.0
T2
CH1CompGain
<4.0:
[1]
SYNC
Enables the digital synchronization signal that indicates which channel the
controller is signaling for each gate switching period on the IC’s SYNC pin.
The SYNC bit should be enabled for non-isolated second stage designs
where the synchronizer circuit is directly driven from the IC's SYNC pin.
0 = Disables SYNC onto pin
1 = Enables SYNC onto pin
[0]
POL_ZCD
Sets polarity of zero-current detection comparator output. Recommended to
set bit POL_ZCD to active-low polarity.
0 = Active-low polarity
1 = Positive polarity
7
6
5
4
3
2
1
0
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
7
6
5
4
3
2
1
0
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
T2
Compensated
T2
=
Measured
T
ZCD Ri
gEdge
sin
T2
CH1CompGain
–
T2
CH1CompGain
T2CH1GAIN[5:0] 0.0625
=
dim
min
S2DIM[7:0] 16 15
+
4095
--------------------------------------------------------
100
=
TTMAX[7:0] 128 127
+
50ns