Revolabs FLX2 VoIP Advanced - Manual (Page 16)

16
Initial Setup
After unpacking the FLX2 Conferencing System, there are a few initial setup tasks that
must be performed before a call can take place or any system configuration can be
changed.
Connecting System Cables
The FLX2 Charger Base has a power supply that needs to be connected, as shown
below. In addition, the Base Station needs to be connected to the network using the
provided Ethernet cable before a conference call can be made. The FLX unit expects
Power over Ethernet (PoE) to be provided through the network connection. If your
network does not support PoE, a power injector is required. Please contact your
reseller to purchase the additional PoE power injector. The Base Station offers
additional optional connections that are only being used when the FLX2 System for
example is connected to a video conferencing unit or a recording device. The cables
required for these connections are not included with the FLX2 system and need to be
purchased separately.
System Setup
Before using the FLX2 to make a call, you will need to select the system language to be
used for the screens. The six options are English, Español
(Spanish), Français (French), Deutsch (German), Italiano
(Italian), and Português (Portuguese). Please highlight the
language of your choice and press ‘Enter’ or ‘Select’.
Note: If a wrong language was selected at this time, it can be
change it later on in the admin area of the menu. However, you
will have to navigate through the menu to get to that option using
the language you selected. So be careful that you do not select a
language you are unfamiliar with.
VoIP configuration
For the FLX phone to work within a VoIP environment the
phone has to be set up to communicate to the IP PBX. You