Revolabs FLX2 VoIP Advanced - Manual (Page 21)

21
Placing a VoIP Call
1. From the home screen on the FLX Dialer enter the
phone number to be called.
2. Once the number is entered completely, press the
green ‘call’ button to initiate the phone call.
3. If any Microphones are out of the Charger Base and
active, the call will default to ‘speaker mode’ and
will be identified by the ring tone being played out of
the Speaker.
4. If no Microphones are outside the Charger Base the
call will default to ‘handset mode’ and the call will
take place on the FLX Dialer.
Once a call has been started, the home screen will show
the two available phone lines and the activity on each line.
In this case, the outgoing call is being made on line 1. The
green phone symbol represents an active call.
Answering an Incoming Call
1. When the FLX2 System identifies an incoming call,
it will play the ring tone through the FLX Speaker. If
the Dialer is not in the Charger Base it will play a
ring tone, too.
2. The FLX Dialer will display the caller ID information
for the incoming call. The yellow phone symbol
represents an incoming call
, in this case on line
one.
3. A call can be answered in one of three fashions.
a. Press the Green ‘Call’ button or the ‘Answer’
key on the FLX Dialer.
b. Remove a Microphone from the charger.