Revolabs FLX2 VoIP Advanced - Manual (Page 60)

60
Network Settings
Connection Type Select the network connection type, either DHCP or Static IP. If
you choose Static IP, specify the Static IP Address, Subnet Mask,
and Default Gateway in the fields below.
Static IP Settings
Static IP Address The Static IP Address is the IP address that the network
administrator has assigned to the phone.
Subnet Mask Subnet Mask is used to determine the subnet to which the phone
belongs, for example, 255.255.255.0.
Default Gateway The Default Gateway is the phone’s default router on the IP
network. It is usually the router connecting the internal network
with the outside network.
Domain Name This is the network domain name.
Primary DNS
Server This is the address of the primary Domain Name System (DNS)
server that translates domain names into IP addresses. Sites
often configure a primary DNS server and a secondary backup
DNS server.
Secondary DNS
Server This is the address of the secondary DNS server.
VLAN Settings
Voice VLAN The options are Enabled, Disabled, or Automatic. “Enabled”
indicates that a VLAN is used. The Voice VLAN ID has to be
specified, the system is not trying to determin the VLAN
automatically. Use this setting if the FLX was not able to detect
the VLAN environment automatically.
“Disabled” switches off VLAN capabilities. The FLX will only
communicate using the standard IP network.
“Automatic” should be used in environments that provide a Voice
VLAN with automatic detection. The FLX will determine the VLAN
identifier and register in that network.
Voice VLAN ID Manually specify a VLAN identifier. This setting requires the
Voice VLAN selector to be “Enabled”.
NTP Servers
Server 1 –
Server 4 Specifies the IP addresses of NTP (Network Time Protocol)
servers. The FLX will provide standard NTP servers at start-up. If
local NTP servers or other NTP servers should be used, provide
them in these settings.