Revolabs FLX2 VoIP Advanced - Manual (Page 81)

81
Sony XG-80 Mic Input Mic 07-35MUTO35MU-01 Line Output 07-35MUTODRCA-01
Sony PCS-G70 Mic Input Mic 07-35MUTO35MU-01 Line Output 07-35MUTODRCA-01
Sony PCS-HG90 Mic Input Mic 07-35MBTOXLR-01 Line Output 07-35MUTODRCA-01
Sony PCS-G50 Mic Input Mic 07-35MUTO35MU-01 Line Output 07-35MUTODRCA-01
Sony PCS-1 Mic Input Mic 07-35MUTO35MU-01 Line Output 07-35MUTORCA-01
Panasonic KX-VC600
Audio In
L/R
Line 07-35MUTODRCA-01 Line Output 07-35MUTODRCA-01
Panasonic KX-VC500
Audio In
L/R
Line 07-35MUTODRCA-01 Line Output 07-35MUTODRCA-01
Panasonic KX-VC300
Audio In
L/R
Line 07-35MUTODRCA-01 Line Output 07-35MUTODRCA-01
To connect a FLX to a computer we recommend using Revolabs’ USB connector kit,
01-USBAUD35-KIT. This kit includes a USB audio dongle and two cables to connect to
the FLX.
Troubleshooting
Warning Messages
Speaker / Microphone Link Lost
If a FLX Microphone or FLX Speaker loses connection to the FLX2 Base Station, the
LED indicator will begin flashing a sequence of red – yellow - green - yellow and start
emitting a beeping notification. To reconnect the Microphone or Speaker move it back
into range of the Base Station.
Speaker/Microphone Low Battery
If a FLX Microphone or FLX Speaker begins to experience a low battery, the LED
indicator will begin to flash a green - yellow (unmuted) or red - yellow (muted)
sequence. It will also start to emit an audio signal. When this LED and sound sequence
begins, the battery has roughly 5% battery power remaining and should be returned to
the Charger Base.
Speaker/Microphone Off
If the FLX Microphone or FLX Speaker suddenly turns off, it is the result of two possible
causes.
1. The battery has completely depleted and should be returned to the charger until
it is fully charged again.
2. The Microphone or Speaker lost connection with the Base Station for more than
10 minutes and therefore shut down. It should be returned into reach of the Base
Station and switched on again to be reactivated.
Dialer Low Battery
When the Dialer experiences a low battery it will display a ‘low battery’ notification on
the screen. The Dialer should be returned to the charger until the battery status on the
home screen shows a full charge.