Revolabs FLX2 VoIP Advanced - Manual (Page 76)

76
#0 G722 @16KHz, sendrecv, peer=10.134.122.95:13400
RX pt=9, stat last update: 00h:00m:05.390s ago
total 1.1Kpkt 179.3KB (224.2KB +IP hdr) @avg=57.1Kbps/71.4Kbps
pkt loss=0 (0.0%), discrd=0 (0.0%), dup=0 (0.0%), reord=0 (0.0%)
(msec) min avg max last dev
loss period: 0.000 0.000 0.000 0.000 0.000
jitter : 0.000 2.004 14.625 2.625 2.186
TX pt=9, ptime=20ms, stat last update: 00h:00m:00.110s ago
total 1.2Kpkt 200.6KB (250.8KB +IP hdr) @avg 63.8Kbps/79.8Kbps
pkt loss=0 (0.0%), dup=0 (0.0%), reorder=0 (0.0%)
(msec) min avg max last dev
loss period: 0.000 0.000 0.000 0.000 0.000
jitter : 0.375 3.925 15.000 15.000 5.570
RTT msec : 0.000 1.810 5.020 2.014 1.840
Power On/Off the System Components
During normal use and operation of the FLX2 System, there is no need to turn off any
part of the system. However, if the system is going to be stored without the Charger
Base powered on, then each component should be powered off until further use.
Dialer On/Off
To power off the FLX Dialer, hold down the red ‘end call’ soft key until the device asks
whether you want to shut it down. Confirm this by pressing ‘Yes’.
To turn the Dialer back on, either:
1. Hold down the red ‘end call’ soft key until the Dialer powers on.
OR
2. Simply return the Dialer to an active Charger Base and it will power on
automatically.
Speaker On/Off
To power off the FLX Speaker, hold down the button located on the bottom of the
Speaker until the LED indicators on the top of the Speaker turn solid red. Once the LED
indicators are solid red, release the button and the Speaker will power off.
To power the Speaker back on, either:
1. Hold down the button on the bottom of the Speaker until the LED indicators on
the top of the Speaker turn green. Once the LED indicators turn green, release
the button and the Speaker will power on and connect to the system.
OR
2. Simply return the Speaker to an active Charger Base and it will power on
automatically.