Lenovo Secure Managed Client - Manual (Page 29)

Note: Do not turn the lock more than half a turn; otherwise, the drive carrier
may be damaged.
3.
Remove the screwdriver.
De-activating an anti-tamper lock
To deactivate an anti-tamper lock, do the following:
1.
Carefully insert the TORX* screwdriver provided into the cutout in the handle
(see 1 in the following figure).
2.
Turn the screwdriver in a counter-clockwise direction until the lock symbol is
no longer visible in the opening beside the key (see 2 ).
Note: Do not turn the lock more than half a turn; otherwise, the drive carrier
may be damaged.
3.
Remove the screwdriver.
Removing and installing a hard disk drive into a drive carrier
To remove and install a hard disk drive into a drive carrier, do the following:
Removing a hard disk drive from a drive carrier
To remove a hard disk drive from a drive carrier, do the following:
1.
Observe all safety and ESD precautions in the Safety and Warranty Guide.
2.
See “Removing a drive carrier module” on page 17 for instructions on
removing a drive carrier from a drive bay.
3.
Remove the four screws securing the hard disk drive to the drive carrier (see
1 in the following figure). Lift the hard disk drive out of the drive carrier.
Figure 21. Activating an anti-tamper lock
Figure 22. Deactivating an anti-tamper lock
Chapter 3. Hardware installations and upgrades 21