Lenovo Secure Managed Client - Manual (Page 33)

Table 1. (continued)
4 DIMM_B2 8 DIMM_D2
7.
Make sure the clips at each end of the DIMM socket are pushed outward to
the open position (see 1 in the following figure).
8.
Holding the FBDIMM by its edges, remove it from its anti-static package.
9.
Position the FBDIMM above the socket. Align the notch on the bottom edge of
the FBDIMM with the key in the DIMM socket. In the following figure, 2 is
pointing to the key in the socket.
10.
Insert the bottom edge of the FBDIMM into the socket.
11.
When the FBDIMM is inserted, push down on the top edge of the FBDIMM
until the retaining clips snap into place (see 3 ).
12.
Make sure the clips latch firmly in place (see 4 ).
13.
Repeat the previous six steps for any additional FBDIMM installs.
14.
Re-install the processor air duct. For instructions, see “Installing the processor
air duct” on page 9.
15.
Re-install the enclosure cover. For instructions, see “Installing the enclosure
cover” on page 7.
16.
Reconnect all peripheral devices and the AC power cord(s). Power up the
storage system.
Removing and installing an Ethernet card
To remove and install an Ethernet card, do the following:
Removing an Ethernet card
To remove an Ethernet card, do the following:
1.
Observe all safety and ESD precautions in the Safety and Warranty Guide
2.
Turn off all peripheral devices connected to the storage system. Turn off the
storage system.
3.
Disconnect the AC power cord(s).
Figure 26. Installing FBDIMMs
Chapter 3. Hardware installations and upgrades 25