Lenovo Secure Managed Client - Manual (Page 39)

7.
Re-install the enclosure cover. For instructions, see “Installing the enclosure
cover” on page 7.
8.
Reconnect all peripheral devices and the AC power cords. Power up the
storage system.
Installing the boot drives
To install the boot drives, do the following:
Attention:
v Turn off and wait 30 seconds for drives to spin down before removal.
v When handling drives, ensure that they are placed (and stored) on a cushioned
surface.
Note: You can replace individual boot drives or the complete boot drive module.
1.
Observe all safety and ESD precautions in the Safety and Warranty Guide.
2.
Turn off all peripheral devices connected to the storage system. Turn off the
storage system.
3.
Disconnect the AC power cord(s).
4.
Remove the enclosure cover. For instructions, see “Removing the enclosure
cover” on page 6.
5.
Remove the processor air duct. For instructions, see “Removing the processor
air duct” on page 8.
6.
Loosen the two captive screws securing the brace assembly to the enclosure
(see 1 in the following figure). Lift brace assembly out of the enclosure (see
Figure 31. Installing the Intel RAID Controller SRCSATAWB
Chapter 3. Hardware installations and upgrades 31