Removing the tr 700 battery – Lenovo ThinkServer TD340 User Manual
Page 128
Note: Carefully handle the ThinkServer RAID 700 Adapter by its edges and place it on a flat, clean,
and static-protective surface after you remove it.
6. Touch the static-protective package that contains the TR 700 Battery to any unpainted surface on the
outside of the server. Then, take the TR 700 Battery out of the package.
7. Position the TR 700 Battery above the ThinkServer RAID 700 Adapter so that the board-to-board
connector
1
on the bottom of the TR 700 Battery is aligned with the connector
2
on the ThinkServer
RAID 700 Adapter; and the three mounting studs on the bottom of the TR 700 Battery are aligned with
the corresponding holes in the ThinkServer RAID 700 Adapter. Carefully press the TR 700 Battery onto
the ThinkServer RAID 700 Adapter until the two connectors (
1
and
2
) are firmly joined. Then, install the
three screws that come with the TR 700 Battery option kit to secure the TR 700 Battery in place.
Notes:
• Center the screwdriver when you install the screws and do not over-tighten the screws to avoid
possible damage to any parts.
• Do not touch the board on the bottom of the TR 700 Battery.
Figure 61. Installing the TR 700 Battery
8. Reinstall the ThinkServer RAID 700 Adapter with the TR 700 Battery. See “Installing or removing the
9. Reinstall the PCI card bracket assembly. See “Removing and reinstalling the PCI card bracket
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 205.
Removing the TR 700 Battery
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 83.
This topic provides instructions on how to remove the TR 700 Battery if your server has a ThinkServer RAID
700 Adapter with a TR 700 Battery option installed.
116
ThinkServer TD340 User Guide and Hardware Maintenance Manual