Lenovo ThinkServer TD340 - Manual (Page 191)

8. Lift the release latch 1 and slide the hard-disk-drive cage out of the front of the chassis.
Note: The following illustration shows the 3.5-inch hard-disk-drive cage. For the 2.5-inch hard-disk-drive
cage, the removal procedure is the same.
Figure 120. Removing the hard-disk-drive cage
9. Depending on whether your server has 2.5-inch hot-swap hard-disk-drive cages with backplanes or
3.5-inch hot-swap hard-disk-drive cages with backplanes, do one of the following:
• For the 3.5-inch hot-swap hard-disk-drive backplane, remove the four screws that secure the
backplane, and then remove the backplane from the hard-disk-drive cage.
Figure 121. Removing the 3.5-inch hot-swap hard-disk-drive backplane
Chapter 6 . Installing, removing, or replacing hardware 179