Lenovo Secure Managed Client - Manual (Page 51)

Chapter 6. Using the Setup Utility
The Setup Utility program is used to view and change the configuration settings of
your storage array, regardless of which operating system you are using. However,
the operating-system settings might override any similar settings in the Setup
Utility program.
Starting the Setup Utility program
To start the Setup Utility program, do the following:
1. If your storage array is turned on when you start this procedure, shut down
the operating system and turn it off.
2. Turn on the storage array, after you hear multiple beeps, the following message
will be displayed:
Press <ESC> to view diagnostic messages
Press F2 to enter setup, F12 Network Boot
3. Press and release F2 key to enter setup.
Note: If a user password or an administrator password has been set, the Setup
Utility program menu is not displayed until you type your password. For
more information, see “Using passwords.”
The Setup Utility might start automatically when POST detects that hardware has
been removed or new hardware has been installed in your storage array.
Viewing and changing settings
The Setup Utility program menu lists items that identify system configuration
topics. To view or change settings, see “Starting the Setup Utility program.”
When working with the Setup Utility program menu, you must use the keyboard.
The keys used to perform various tasks are displayed at the bottom of each screen.
Additional information about Setup Utility program settings is often displayed on
the right side of the screen.
Using passwords
By using the Setup Utility program, you can set passwords to prevent
unauthorized persons from gaining access to your storage array and data. See
“Starting the Setup Utility program.” The following types of passwords are
available:
v User Password
v Administrator Password
You do not have to set any passwords to use your storage array. However, if you
decide to set any passwords, read the following sections.
© Lenovo 2008. Portions © IBM Corp. . 45