Barco R9001960 - Manual (Page 110)

B. BARCO Control Manager
Set up
To set up the time and date, handle as follow :
1. Select the time zone by clicking on the corresponding time zone in the Time zone list. (image B-17)
2. Select ’network time’ by checking the network time box and fill out the IP-address of your local NTP server. This server gives
normally the GMT time, but due to time zone indication, the correct time will be filled out in the time and date text box after Apply
is click.
The ’Time’ and ’Date’ area will be grayed out but filled out with the correct time and date. The current time on projector will be
adapted.
Or ,
Fill out the time and date text box with the following mask :
Time : hh:mm
Date : dd-mm-ccyy
The NTP server address box will be grayed out.
3. Click on Apply to activate.
The current time on projector will be adapted.
Image B-17
Date & time setup screen
Each time the projector is powered down, the date & time settings has to be filled out again when chosen for
the second methode.
B.5.5 Settings
What can be done
The projector nick name, location and SMTP server address can be filled in.
106 R5976182 BARCOREALITY 6500 30012001