Barco R9001960 - Manual (Page 32)

4. Getting Started
Image 4-1
RCU function indication
1 Function keys user programmable keys with functions for direct access.
2 ADJ. Adjust key, to enter the adjustment mode
3 Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
4 Selection key (*) to direct access the zoom/focus/shift functions.
5 PAUSE to stop projection for a short time, press ’PAUSE’. The image disappears but full power is
retained for immediate restarting.
6 STBY standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds until the message ’Saving data,
please wait’ is displayed. Do not press any longer on the standby key otherwise
the projector will restart.
7 MUTE to interrupt the sound reproduction.
8 ? Auto image, to center the image on the active LCD surface.
9 Digit buttons direct input selection.
10 Audio controls use these buttons to obtain the desired sound level.
11 Picture controls press to adjust the projected image.
12 Phase press to adjust the phase of the projected image.
13 FREEZ press to freeze the projected image.
28 R5976182 BARCOREALITY 6500 30012001