Barco R9001960 - Manual (Page 35)

4. Getting Started
4.3.2 Switching to standby.
How to switch to standby?
1. Press STANDBY for 2 seconds until the messages Saving data please wait is displayed. (image 4-5)
Note: Do not press any longer on the STANDBY key otherwise the projector will restart.
Image 4-5
When switching to standby, it is possible to restart within the first 5sec.. When not restarted within these first
5 sec., the projector waits for 1 min. to restart again. During this period the LED display will show a jumping
square with a dash. After one minute, two dashes will be displayed and the projector can restart.
4.3.3 Switching off
How to switch off the projector?
To switch off the projector, handle as follow :
1. Press STANDBY key for 2 seconds. When the message Saving data, please wait is displayed, do not press any longer on the
STANDBY key otherwise the projector will restart.
Warning:
Let cool down the projector at least 10 min.
2. Switch off the projector with the power switch.
4.4 Quick Set Up Adjustments
Overview
• Quick lens Adjustment
• Quick on Screen Color Change.
4.4.1 Quick lens Adjustment
Quick zoom/focus adjustment
1. Press the Selection key *.
The zoom/focus menu will be displayed.
2. Push the cursor key
↑
or
↓
to zoom and
←
or
→
to focus the image.
3. When finished, press EXIT key to return or ENTER to continue to the shift adjustment.
Quick shift adjustment
1. Press the Selection key *
The zoom/focus menu will be displayed.
2. Press ENTER.
The shift menu will be displayed.
Or ,
Push the cursor key
↑ or ↓ to shilft the image up or down and ← or → to shift the image left or right.
3. When finished, press EXIT key to return or ENTER to continue to zoom/focus.
4.4.2 Quick on Screen Color Change.
What can be done ?
For quick change of the the on-screen color of the highlighted items.
The highlighted items on the menus can be displayed in red, green or yellow.
R5976182 BARCOREALITY 6500 30012001 31