Barco R9001960 - Manual (Page 77)

8. Installation mode
Defining the output module
To define the output modul:
1. Push the cursor key
↑
or
↓
to highlight 800 Peripheral. (menu 8-26)
2. Press ENTER to select.
3. Push the cursor key ↑ or ↓ to highlight Output module. (menu 8-27)
INSTALLATION
800 PERIPHERALS
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
SWITCHING MODE : [BLANKING]
SHUTTER
more ...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 8-26
800 PERIPHERAL
OUTPUT MODULE [STANDARD]
INFRARED [PPM]
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 8-27
8.10.2 Defining the Infrared Communication protocol
Which protocols are available?
When a peripheral is connected to the ’Comm Port’, the communication can be in PPM or RC5.
The type of communication can be set to :
• PPM
• RC5
Defining the communication protocol.
1. Push the cursor key ↑ or ↓ to highlight 800 Peripheral. (menu 8-28)
2. Press ENTER to select.
3. Push the cursor key
↑
or
↓
to highlight Infrared. (menu 8-29)
4. Press ENTER to select.
5. Press ENTER to toggle between [PPM] or [RC5].
INSTALLATION
800 PERIPHERALS
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
SWITCHING MODE : [BLANKING]
SHUTTER
more ...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 8-28
800 PERIPHERAL
OUTPUT MODULE [STANDARD]
INFRARED [PPM]
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 8-29
8.11 Configuration
What can be done?
The way of physical installation of the projector can be defined to the projector.
The following installation configurations are possible:
• front/table
• front/ceiling
• rear/table
• rear/table
R5976182 BARCOREALITY 6500 30012001 73