Toshiba Magnia Z500 - Manual (Page 120)

Installing and Removing Hardware
Hard Disk Drive (HDD) –IDE HDD–
101
1 Remove the front panel.
2 Confirm the position of a faulty device.
The STS indicator of the faulty device is lit amber.
CAUTION: The hard disk drive generates heat when in use.
To avoid burns, hold the disk tray when removing the hard
disk drive.
3 Start the MegaRAID Configuration Console (MCC).
4 Tilt over the detachable lever of the slot which holds a defec-
tive hard disk drive, by pulling its knob toward you.
Pulling the detachable lever toward you
NOTE: Before pulling out the hard disk drive, make sure that
it is faulty. If a normally operating device is pulled out by mis-
take, it may damage the server or destroy and lose important
programs or data.