Toshiba Magnia Z500 - Manual (Page 181)

System Configuration Setup
Configuring MegaRAID IDE
162
1 Turn on the computer and Press the <Ctrl> + <M> keys to start
the MegaRAID IDE Setup Utility while it is booting.
2 Create an array by using F4 Option. Change the array type to
Mirror.
3 The existing drive and the new drive are included in this array.
You can identify the existing drive and the new drive by where
they are connected.
4 Start the rebuilding process by pressing the <Enter> key. The
setup will prompt for the target drive name. Select the newly
connected drive as the target drive by pressing the <Space>
key and then <Enter> key.
5 The rebuilding process will start. If there are any errors during
the rebuilding of the array, you will be prompted with a mes-
sage box. You can choose to ignore the error and proceed, or
stop the rebuilding process.
NOTE: To make the rebuilding process faster, enable DMA
Read/Write using the <F7> key.
Using the MegaRAID IDE Setup Utility
MegaRAID IDE Setup Utility
The MegaRAID IDE Setup Utility has three sections:
! Array Information
! Physical Drive Information
! Help
Only the Array Information window and Physical Drives Informa-
tion window are active. The Array Information window is
editable. The Physical Drives Information window is not editable.