Pulling out the hard disk drive, 6 click the “scan device” of the mcc screen, 9 attach the front panel – Toshiba Magnia Z500 User Manual
Page 121: 10 click the “scan device” of the mcc screen
Installing and Removing Hardware
Hard Disk Drive (HDD) –IDE HDD–
102
5 While holding the disk tray, carefully remove the hard disk
drive that is pulled out halfway.
NOTE: When removing the hard disk drive, the OS may stop
for a few minutes.
Pulling out the hard disk drive
6 Click the “Scan Device” of the MCC screen.
7 Install a new hard disk drive in the same procedure as for
extension.
See “Installing the hard disk drive” on page 98.
8 After a short time, confirm that the PWR indicator lights up.
9 Attach the front panel.
10 Click the “Scan Device” of the MCC screen.
Rebuild array starts automatically. If the rebuild array does not
start, click the “Scan Device” again. The progress of the
rebuild can be checked on the “Device Progress” of the MCC
screen. When the rebuild is completed, the message “Rebuild
COMPLETED Successful” is written to the Log Date of the
MCC screen.