Toshiba Magnia Z500 - Manual (Page 199)

Installing Software
Windows® 2000 Server
181
Procedure after installation of the device driver
After the installation of the device driver is complete, follow the
procedure mentioned below:
1 Activate the Windows 2000 Server and log in the user ID of
the Administrator or a person having the competence equiva-
lent to that of the Administrator.
2 If no network has been built up, set up the network.
3 If no TCP/IP has been set for the network, set it.
See “Windows 2000 Server User's Guide or Help” for details
of TCP/IP setting.
4 Install the SNMP Service in the network.
For installing the SNMP Service, use “Services”, which can be
opened by selecting “Control Panel”, “Network” and “Ser-
vices” of the Windows 2000 Server in this order.
See “Windows 2000 Server User's Guide or Help” for details
of installation.
5 Install the Service and Software (Power Console Plus) of the
RAID Controller (when the RAID Controller is additionally
connected) or MegaRAID Configuration Console (when IDE
RAID is used).
6 Install the IDE Hotswap Backplane Driver (when IDE RAID
is used).
Use the floppy disk supplied with the RAID Controller for
installation.
See “MegaRAID Software Guide” for details of installation.