Toshiba Magnia Z500 - Manual (Page 176)

System Configuration Setup
SCSI Utility
157
! SCSI Controller ID : 7
Specifies the SCSI ID of the SCSI controller. Do not change
this setting.
! SCSI Controller Parity : Enabled
Controls whether the SCSI controller performs parity checks
and scans for normal data transfer through the SCSI bus.
! Boot Device Configuration
Specifies the SCSI device from which the system is to be
booted.
! SCSI Device Configuration
Specifies detailed configuration information for each SCSI
device (SCSI ID).
The following submenu appears:
Sync Transfer Rate (MB/Sec)
Specifies the maximum synchronous transfer rate of the
onboard SCSI controller.
Initiate Wide Negotiation
Set this item to Yes to specify Wide SCSI (16 bit data
width).
Enable Disconnection
Set this item to Yes to make the SCSI controller activate the
disconnect/reconnect function and permit multiple-com-
mand processing.
Sync Transfer Rate (MB/Sec): [160]
Initiate Wide Negotiation: [Yes]
Enable Disconnection: [Yes]
Send Start Unit Command: [Yes]
BIOS Multiple LUN Support: [No]
Include in BIOS Scan: [Yes]