Brother 882-S90/S91 - Manual (Page 140)

BEFORE EMBROIDERING
Embr
oi
de
ry
129
5
d
Turn the main power to ON.
→ The following message will appear.
e
Press .
→ The carriage will move to the initialization position.
The message will disappear after 15 seconds or press
to move to the next step.
■ Removing the Embroidery Unit
a
Press either or , then press
.
→ The carriage will move to the removal position.
b
Turn the main power to OFF.
c
Hold down the release button, and pull the
embroidery unit away from the machine.
a Release button
Note
• A confirmation message to lower the frame-
securing lever after the carriage moves to its
initial position.
CAUTION
• Always remove the embroidery frame before
pressing . Otherwise, the frame may
strike the embroidery foot, and possibly cause
injury.
• The embroidery unit will not fit in the storage
case if this step is not done.
Note
• Be sure to turn the main power to OFF.
Otherwise, the machine may be damaged.
CAUTION
Do not carry the embroidery unit by holding the
release button compartment.
a