Brother 882-S90/S91 - Manual (Page 228)

ERROR MESSAGES
Ap
pe
ndi
x
217
8
ERROR MESSAGES
If the machine is not properly set and the “Start/Stop” button or the “Reverse/Reinforcement Stitch” button
is pressed, or if the operation procedure is incorrect, the machine does not start. An alarm sounds and an
error message is displayed on the LCD. If an error message displays, follow the instructions in the
message.
Below is an explanation of 55 error messages. Refer to these when necessary (if you press or do
the operation correctly while the error message is displayed, the message disappears).
CAUTION
• Be sure to rethread the machine. If you press the “Start/Stop” button without rethreading the machine,
the thread tension may be wrong or the needle may break and cause injury.
This message is displayed when
the motor locks due to tangled
thread or for other reasons
related to thread delivery. This message is displayed if the
is touched when
an unusable embroidery card is
inserted.
This message is displayed when
a button, such as the “Start/Stop”
button, is pushed while the
presser foot is raised. This message is displayed when
there is no stitch or embroidery
pattern selected and the “Start/
Stop” button or the “Reverse/
Reinforcement Stitch” button is
pressed.
This message is displayed when
the upper thread is broken or not
threaded correctly, and the
“Start/Stop” button or the
“Reverse/ Reinforcement Stitch”
button is pressed. This message is displayed when
the “Reverse/Reinforcement
Stitch” button is pushed while the
embroidery unit is attached.
This message is displayed when
the is touched
without an embroidery card
inserted.
This message is displayed when
you try to combine more than 71
patterns.