Brother 882-S90/S91 - Manual (Page 84)

SEWING THE STITCHES
U
tili
ty
S
tit
ch
es
73
3
f
Remove the basting stitches and turn the
fabric over.
a Wrong side of fabric
b Right side of fabric
■ If the Needle does not Catch the
Fold
Adjust the width so that the needle slightly catches
the fold by pressing in the width display.
■ If the Needle Catches Too Much of
the Fold
Adjust the width so that the needle slightly catches
the fold by pressing in the width display.
Appliqué
a
Use a temporary spray adhesive, fabric glue
or a basting stitch to attach the appliqué to
the fabric.
* This will keep the fabric from moving during
sewing.
a Appliqué
b Fabric glue
b
Select or .
* Adjust the stitch length and width to correspond to
the appliqué shape, size, and quality of material (see
page 42).
c
Attach presser foot “J”. Check that the
needle drops slightly off the edge of the
appliqué, then start sewing.
a Appliqué material
a Needle drop position
Memo
Blind hem stitches cannot be sewn if the left
needle drop point does not catch the fold. If
the needle catches too much of the fold, the
fabric cannot be unfolded and the seam
appearing on the right side of the fabric will be
very large, leaving an unattractive finish. If you
experience either of these cases, follow the
instructions below to solve the problem.
a b
Memo
For details on each stitch, refer to the
“STITCH SETTING CHART” at the end of this
manual.
b
a
a
a