Brother 882-S90/S91 - Manual (Page 40)

UPPER THREADING
G
etting
Re
ad
y
29
1
l
Lower the presser foot lever.
m
Holding the thread with both hands, pass
the thread through both the upper and
lower needle bar thread guides.
a Needle bar thread guide (upper)
b Needle bar thread guide (lower)
n
Pass the thread through the eye of the
needle from front to back.
o
Pass the thread through the presser foot,
and then pull out about 100-150 mm
(approx. 4-6 inches) of thread toward the
back of the machine.
a 100-150 mm (approx. 4-6 inches)
p
Press to unlock all keys and
buttons.
Using the Twin Needle Mode
The twin needle can only be used for patterns that
show after being selected. Before you
select a stitch pattern, make sure the stitch can be
sewn in the twin needle mode (refer to the
“STITCH SETTING CHART” at the end of this
manual).
a
Press and install the twin needle
(see “CHANGING THE NEEDLE” on page 34).
b
Manually thread the machine.
* Follow the steps for threading a single needle for the
first threading (see “Threading Manually” on page
27).
1
2
a
b
a
CAUTION
• Use only twin needles made for this machine
(part code X59296-151). Other needles could
break, resulting in damage.
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
• Do not sew with bent needles. The needle
could break and cause injury.
• When using the twin needle, be sure to use
presser foot “J” only.
• When the twin needle is used, bunched
stitches may occur depending on the types of
fabric and thread that are used.
If this occurs, use monogramming foot “N”.