Fluid Management 53PD Blendorama User Manual - Manual (Page 8)

6 | Blendorama Dispenser

Fluid Management Customer Service 1 . 800 . 462 . 2466
Important Safety Information
Grounding
This product must be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electrical shock by providing an escape for the
electric current. This product is equipped with a cord that has a grounding wire
and an appropriate grounding plug. The plug must be inserted into an outlet
that is properly installed and grounded in accordance with all local codes and
ordinances.
Danger
Improper installation of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, DO NOT connect the
grounding wire to either flat blade terminal. The insulation wire with green or
green and yellow stripes on the outer surface is the grounding wire.
Check with a qualified electrician if the grounding instructions are not
completely understood, or if in doubt about whether the product is properly
grounded. Do not modify the plug provided. If it will not fit into the outlet, have
the proper outlet installed by a qualified electrician.
Communications Regulation Information
Safety and Regulatory Compliance Information
See the affixed labeling on the machine. ETL Listed, conforms to UL STD
1450. Certified to CAN/CSA STD C22.2 NO. 68. (120 volt model only.)
•
Warnings
This machine draws 3 amps
at 120 ± 10% VAC.
This machine draws 1.5 amps
at 220/230 ±10% VAC.
DO NOT modify the provided
plug.
Improper use of grounding
plug can result in risk of
electric shock.
Hazardous moving parts.
Keep fingers and other
body parts away.
•
Cautions
Check with a qualified
electrician or service person if
grounding instructions are not
completely understood or if in
doubt as to whether product is
properly grounded.
DO NOT user an adapter
or extension cord with this
product.
This unit must be plugged into a
dedicated electrical line.
To reduce risk of electric shock
or injury, use indoors only.
Never force a connector into a
port. If the connector and port
do not join with reasonable ease,
they probably do not match.
Make sure that the connector
matches the port and that you
have positioned the connector
correctly in relation to the port.