Fluid Management Miller GyroMixer - Manual (Page 11)

UNPACKING DIRECTIONS
GyroMixer End User Guide 7
UNPACKING
DIRECTIONS INSPECT FOR DAMAGE
Inspect the shipping carton for damages. If any damage is found, notify the carrier
at once and arrange for an inspection in order to claim recovery.
Note: Claims for damage must be made by the consignee (you).
The carrier assumes full responsibility upon acceptance of
shipment and will not entertain any claims by the consignor
(Fluid Management).
REMOVE MIXER FROM SKID
1. Place the carton in the area where the mixer will be located.
2. Remove the strapping and the cardboard carton stapled to the skid.
3. Open the sliding door.
4. Remove the two bolts holding mixer to the skid.
5. Slide the mixer back until half of the unit is off of the skid.
6. Carefully tilt the mixer back until its lower rear edge touches the floor
and the skid is free.
Important: Keep the weight of the mixer on its lower rear edge.
7. Pull the skid out from under the front of the unit.
8. Carefully tilt the mixer forward until all four casters are on the floor.
UNPACK THE MIXER
Caution Do not operate the mixer until the shipping
inserts are removed.
1. Open the mixer’s sliding door
2. Remove the two (2) shipping inserts positioned in the base of the mixer.
Note: The inserts are wedged against the sides of the mixer.
3. Record the serial number and model number in the space provided on
page 5. (See the identification label located on the side of the mixer. It is
important data when ordering parts or servicing the mixer.)