Fluid Management Miller GyroMixer - Manual (Page 12)

SETTING UP THE MIXER
8
SETTING UP
THE MIXER INSTALLATION
The following instructions are for both the standard and explosion-proof models.
Refer to the boxes for special information on explosion-proof installations.
1. Move the mixer to its permanent location.
2. Refer to the Electrical Supply section of this manual for power
requirements.
3. Locate the mixer as close as possible to a properly grounded outlet.
4. Leave ample room around the paint mixer to facilitate safe operation and
routine maintenance.
ELECTRICAL CONNECTION
Caution The unit must be plugged into a dedicated
electrical line with no other equipment using the
same circuit. DO NOT use an adapter or
extension cord with this product.
WARNING Improper use of the grounding plug can result in
a risk of electric shock.
Explosion-Proof Installation
• Installation to be completed by a registered master electrician
following local codes and regulations.
• Loosen the screws in order to remove the back cover.
• Referring to the wiring diagram in the Service Section of this manual,
connect the power supply to the explosion-proof box.
The timer, shipped with the mixer, is located within the explosion-proof box.
It is preset for 1-1/2 minutes, but may be adjusted up to 3 minutes by
qualified service personnel.