Fluid Management Miller GyroMixer - Manual (Page 35)

ELECTRICAL
GyroMixer End User Guide 31
5. Verify that all connections fit tightly. Repair any loose connections by
crimping or replacing the loose ones.
6. Reinstall the electrical cover plate and the rear access panel.
7. Plug in the electrical cord and verify that the mixer operates properly.
Make adjustments, if necessary.
ELECTRICAL DRAWINGS
Figure 4. Electrical Schematic
S1 S2
K1 T1
+
-
A B C D
EMERGENCY
STOP START
0
CYCLE
COUNTER
M
SWITCH
1
3
4 5
4 6 2 1
S1 S2
K1 T1
+
-
A B C D
EMERGENCY
STOP START
0
CYCLE
COUNTER
SWITCH
1
3
4 5
6 8 2 1
2 4
L1
L2
GND
L1
L2
GND
ELECTRICAL SCHEMATIC, 100-120V, 50/60Hz
ELECTRICAL SCHEMATIC, 200-240V, 50/60Hz
M
NOTE: THE CONNECTIONS SHOWN FOR S1 & S2
ARE LABELS ONLY. REFER TO TABLE FOR
CORRESPONDING CONNECTIONS.