Fluid Management Miller GyroMixer - Manual (Page 15)

SETTING UP THE MIXER
GyroMixer End User Guide 11
LEVELING
The customer must level the mixer. Although the unit is shipped on casters for ease
of positioning the mixer, all 4 feet must be extended firmly to the floor. Variations
on the floor will necessitate adjusting the leveling feet to ensure proper operation
and to minimize vibration.
CAUTION Improper leveling may cause severe vibration
while the mixer is operating.
1. Roll the unit into its intended location.
2. Lower the four (4) leveling feet to the ground. Each of the four leveling
feet can be adjusted independently. Using the front of the mixer as a
position guide, turn the foot in a clockwise direction to lengthen, or in a
counter-clockwise direction to shorten.
IMPORTANT : The feet should carry the load; not the casters.
Check the stability of the mixer on the floor by making
sure that the mixer is resting on all four feet, not on its
casters. All casters must rotate freely.
3. Verify that the mixer is level by gripping its sides and gently attempting
to rock the machine. It should not move.
4. Lock the leveling feet into place by tightening the upper locknuts to the
mixer bottom with a 3/4" wrench.
Note: Should additional leveling be necessary, loosen the upper
locknuts and repeat steps 2 - 3.