Fluid Management Miller GyroMixer - Manual (Page 13)

SETTING UP THE MIXER
GyroMixer End User Guide 9
Grounding
This product must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electrical shock by providing an escape for the electric current.
This product is equipped with a cord that has a grounding wire and an appropriate
grounding plug. The plug must be inserted into an outlet that is properly installed
and grounded in accordance with all local codes and ordinances.
WARNING Check with a qualified electrician or service
person if grounding instructions are not
completely understood or if in doubt as to
whether product is properly grounded.
WARNING Improper installation of the grounding plug can
result in a risk of electric shock. If repair or
replacement of the cord or plug is necessary, do
not connect the grounding wire to either flat
blade terminal.
The insulation wire with green or green and yellow stripes on the outer surface is
the grounding wire. Check with a qualified electrician if the grounding instructions
are not completely understood, or if in doubt about whether the product is properly
grounded. DO NOT modify the plug provided. If it will not fit into the outlet, have
the proper outlet installed by a qualified electrician.
This product is designed for use in 100 to 240 Volt operation. The power
requirements of your unit will be outlined on the nameplate.
The non explosion-proof model is for use on a nominal 120-volt circuit and has a
grounding plug that looks like the plug illustrated in the figure below. Make sure
that the product is connected to an outlet having the same configuration as the plug.
No adapter should be used with this product.
Note: If product has a nameplate for nominal 220-volt circuit, make
sure the proper grounded outlet is used.
Figure 1. Grounding Methods