ARB 3232200 - Manual (Page 12)

02-08-12 Page 12 of 23 3787827
30. If vehicle is fitted with parking sensors
cut out templates supplied with
instructions. Place outer templates over
indicator recess and inner templates over
high lift jack opening as shown. Mark
holes with a felt tip pen. Drill 16mm holes
in marked positions. File or die-grind
slightly to achieve a snug fit (not a tight
fit). De-burr and paint when done.
31. Install the indicators into the bar using
the self tapping screws (8-AB X 1” pan
head) supplied with the fitting kits.
Discard the screws supplied with the
indicators.
NOTE: The indicators should be installed
with the drain holes at the bottom
32. If there are no fog lights fitted to the
vehicle, fit the fog light insert supplied to
the bar. Fit the fog insert bracket to the
fog light insert with the eight pan head
screws as shown opposite.