ARB 3232200 - Manual (Page 9)

02-08-12 Page 9 of 23 3787827
VEHICLE PREPARATION
14. With all the wiring connections now
made , feed the harness down so that it
sits neatly and retain in place with the
cable ties provided .
Note :- Ensure all wiring will not rub or
touch on any metal parts , sharp
edges and hot or moving parts .
15. Replace the headlight to gain a visual
reference of the line to be cut. Mask the
flare along the line of the headlight.
16. Remove the headlight and remove the
flare.
17. Cut the flare along the line of the
masking tape.
NOTE: Be careful not to cut too much off
the inner tab that attaches the flare to the
guard.
18. Replace the flares making sure to
replace the screw at headlight level.
19. Bend the tag that hangs down below the
line of the guard up and out of the way.
Bend tag
Replace screw