ARB 3232200 User Manual

Page 16

Advertising
background image

02-08-12

Page 16 of 23

3787827

43. Remove the cap head screws retaining

the gearbox to the winch drum. Carefully
lift and rotate the gearbox 144 degrees
counter clockwise (four hole spacings)
and re-fit the cap screws.

44. Lay the winch on a suitable surface and

place the bull bar on top so that the wire
rope will feed from the bottom.

45. Using  two  3/8”  x  1  1/2”  bolts,  M10  flat  and  

spring washers, attach the bull bar to the
winch through the top two holes


46. Using a 12mm drill bit, drill two new holes

in the roller fairlead 25mm below the
original holes.


Drill the new
hole 25mm
below original

Advertising
This manual is related to the following products: