ARB 3232200 - Manual (Page 23)

02-08-12 Page 23 of 23 3787827
WASHER BOTTLE GUARD FITMENT TO BULL BAR
77. Fit two M6 cage nuts to back surface of
guards. Fit the washer bottle stone
guards to both sides of the bull bar .
78. Use the three M6 x 20mm black bolts,
M6 black flat washers and M6 black
spring washers to attach the guards to
the wing along the front and side edges .
79. Attach the M8 x 20mm black bolt , M8
black flat washer and M8 black spring
washer to attach the guard to the impact
absorber as shown .
80. Trim the inner guard in line with the lower
edge of the washer bottle cover .
81. Using the washer bottle guard as a
template mark the position of two cage
nuts located on the rear fold with a paint
marker onto the fender liner .
Drill Using a 8 mm drill bit - drill the two
holes .
82. To fit the license plate to the bar, first
push two nylon plugs into the front face
of the top pan. Fit the license plate using
two 8-18 x 20mm tek screws .
83. Ensure all lights are functioning correctly
and all bolts are fully tightened .
Also supplied in the kit are two 16mm plugs. The two plastic plugs are for the holes in the top
surface of the wings if no CB aerials are fitted.
M8 BOLT
M6 BOLTS